Control Chief TM6000 Manual do Operador descarregar pdf (Página 78)

TM 10-3930-660-10

0006 00-8

OPERATION UNDER UNUSUAL CONDITIONS - CONTINUED 0006 00

TOWING OTHER VEHICLES

WARNING

• Carefully move the forklift into position. Always use a ground guide and any device necessary to lift the tow

bar into position without standing directly between the forklifts. Failure to follow this precaution could

result in personal injury or forklift damage.

• The 6K forklift is equipped with a towing pintle and lugs. Towing should be limited to vehicles weigh-

ing 27,100 lbs (12,292 kg) or less. Whenever the 6K forklift is used to tow another vehicle, use the tow

pintle to attach the tow bar.

TOWING THE 6K FORKLIFT

WARNING

• Carefully move the towing vehicle into position. Always use a ground guide and any device necessary

to lift the tow bar into position without standing directly between the forklifts. Failure to follow this pre-

caution may cause personal injury or forklift damage.

• If the 6K forklift must be towed, tow lugs are used to connect the tow bar. Tow lugs are located at the

rear of the vehicle, on the counterweight.

• Do NOT tow at speeds over 20 mph (32 kph).

NOTE

Contact Maintenance to perform the necessary preparation of the 6K forklift for towing.

1. Position the forks approximately 24 in. (61 cm) above the ground.

WARNING

When the propeller shafts are disconnected and the parking brake disengaged, the forklift may roll and could

result in severe personal injury. Always chock the wheels properly.

2. Chock all wheels.

TOW

PINTLE

TOW LUG

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 200 201

Sem comentários

Control Chief TM6000 Manual do Operador Página 78