Control Chief TM6000 Manual do Operador descarregar pdf (Página 58)

TM 10-3930-660-10

0005 00-6

OPERATION UNDER USUAL CONDITIONS - CONTINUED 0005 00

MOVE FORKLIFT - CONTINUED

3. Changing Direction of Travel

WARNING

DO NOT STOP QUICKLY. The load may drop off the forks causing damage or personal injury.

a. Depress brake or transmission disconnect pedal to apply the service brakes and bring the forklift to a complete stop.

NOTE

When changing direction of travel, reduce engine speed.

b. Move travel select lever through Neutral, “N” to the desired direction.

4. Changing Gear Selection Range

WARNING

DO NOT downshift at high speeds. Forklift will slow suddenly and drop the load or possibly cause operator

injury.

CAUTION

• Operating the vehicle with a heavy load in high gear will cause the torque converter to slip excessively and

the transmission may overheat.

• Upshifting and downshifting should be done in the normal sequence of speeds.

NOTE

The gears should be engaged only after reaching the top speed of the next lower gear. If necessary, the fork-

lift should be slowed by means of the service brakes.

a. Shifting to the next higher gear may be accomplished at any engine RPM while the forklift is in motion.

b. When downshifting, DO NOT over-rev the engine. Allow forklift to slow before shifting to the next lower gear.

5. Accelerating Hydraulic Functions

a. Depress and hold transmission disconnect pedal.

b. Depress accelerator pedal to increase and maintain higher engine speed.

c. Perform desired hydraulic functions.

d. Reduce engine speed to idle after operations are completed.

e. Shift travel select control lever as necessary.

f. Slowly release transmission disconnect pedal.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 200 201

Sem comentários

Control Chief TM6000 Manual do Operador Página 58